Thursday, April 12, 2012

TP2 Power Steering Module

Customer came in with no power steering. 

Power steering module that we replaced

Located right behind the steering wheel.

Easy as removing three bolts no need to rip up the whole dash.

Sunday, March 11, 2012

Honda Insight Hybrid HV Battery Replacement

First thing we did was print out HV Battery removal procedures from Alldata


HV Battery is found in the back trunk.  There is a center plate that opens for the HV Battery disable switch.

After removing the outer shell you will see this above.  The HV Battery is the unit on the right side.



Remove HV Battery with battery mount out of the car.  Insert new battery and put everything back.

Done!!!

Saturday, February 25, 2012

Harvest The Stator

Brand new MG2 came in and I was responsible for removing the stator from MG2.

Remove all bolt on top except for the three bolts in the middle of MG2.

The three bolt in the middle holds the center magnet down. 

If there is no transmission fluid in  MG2..... Add transmission fluid for easy extraction.

Shell without the Stator.

Stator Harvested from MG2

Wednesday, February 15, 2012

Broken Water Pump

Gen 2 Prius taxi came in with a loud whining noise.  We concluded that it was the water pump.  We followed where the sound was coming from and we also noticed pink coolant all over the area.  We first drained the coolant then we remove and replaced the water pump.

All the pink coolant confirms a leak coming from the water pump.

Fixed... New water pump.

Bad Water pump.


After installing the water pump.  Before you start the car... connect  Techstream and  manually activate the  water pump  with the computer.  Do this about two times so coolant can run through before you start the car.   After starting the car use a pedal depressor on the accelerator.  As the engine runs you add coolant and make sure that the thermostat opens and the fans run about two or three times.    Erase any codes left in the car.

Tuesday, February 14, 2012

Noise in the Axle

Nissan Altima taxi came in with noise coming from the passenger side axial.  So we end up changing the axle.

Remember top remove the tiny wheel sensor  and or have a pan ready  to catch the transmission fluid  before you pull the Axle.

Axle removed

Make sure you have everything on the new Axle before you  install it.

Done and all ready to go.  Don't forget the wheel sensor and  top off the transmission fluid before you finish the job.